Mytricity IoT Power Meter

Power Meter·Connecting…

Welcome

Sign in to see your meters.

Add your meter

Enter the meter ID and view key you received with your meter.

All sites

Meters
–
Online now
–
Using now
–
Used today
–
Accounts
–
Create a new meter
MeterStatusNowTodayOwnerLocation
Map shows pinned sites (●) and estimates from each meter's internet connection (○).

Accounts

EmailMetersJoinedLast sign-in
Mains now
– W
– A
☀ Solar now
– W
Today from 12 am
– kWh
Peak today
– W
Recorded at this site
–
Since last restart
–
Energy
–
Average
–
Peak
–
Est. cost
–
Solar generated
–
Solar peak
–
☀ Solar monitoring
Generating now
–
Generated today
–
Peak today
–
DC voltage
–
Appliances on now
Checking…
All appliances ›

My meters

Add a meter
The first account to add a meter becomes its owner and can change its settings. Others who add it can view it.

Settings

Tariff (this browser)
Account
Signed in as
Site location (used by solar sizing)
Locating…
Open in Google Maps
Tap the map where the meter is (or drag the pin). Use the layer button to switch to satellite view.
Electrical (for everyone who views this meter)
Voltages set inside the meter
The meter works out watts with the voltages entered on its own Wi-Fi page (mains 240 V unless you changed it). The dashboard rescales watts and kWh by your voltage ÷ the meter's voltage. Frequency is shown for reference; the clamp reading doesn't depend on it.
Cloud connection (advanced)
Meter
Calibration
Raw ADC signal now: –  (zero = –, gain = – A/count)
1) Switch everything off on the clamped cable (or unclip the CT) → Capture zero.
2) Turn on a known load (kettle/heater). Enter the amps from a clamp meter, or watts ÷ volts → Calibrate.
Solar DC lines (up to 3)
I2C devices found: –
Cloud upload (Supabase)